Viper 5002 Manuel d'utilisateur télécharger pdf (Page 45)

Valet Mode and the battery is disconnected for any reason, such

as servicing the car, when the battery is reconnected the unit will

still be in Valet Mode. This applies to all states of the system

including arm, disarm, VRS

, and Valet Mode.

ppoowweerr ssaavveerr mmooddee

Your system will automatically enter Power Saver Mode while

armed or in Valet

Mode, after a period of time in which no

operation has been performed. This lowers the current draw to

the vehicle’s battery. Power Saver Mode takes over under the

following conditions:

➤ Power Saver when the system is armed: After the system has

been armed for 24 hours, the in-vehicle LED will flash at

half its normal rate, decreasing the system's current draw.

➤ Power Saver in Valet

Mode: When the system enters Valet

Mode the in-vehicle LED illuminates steadily. If the vehicle

is not used (ignition is not turned on) for a period of one

hour while the system is in Valet

Mode, the LED will shut

off. If the system remains in Valet

Mode, the LED will

come back on the next time the ignition is turned on and

then back off.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 60 61

Pas de commentaire

Viper 5002 Manuel d'utilisateur Page 45