Viper 5901 Manuel d'instructions télécharger pdf (Page 19)

minutes and 1 minute of runtime remaining, it sends the 2-way remote

control a paging signal.

Points to remember

If the hood is open or if the brake pedal is pressed, the vehicle will not

remote start.

The remote start shuts down:

When the brake pedal is pressed.s

The hood is opened.s

When the remote start command is sent again from a remote s

control.

7HENTHERUNTIMEEXPIRESs

To drive your vehicle after it has been remote started:

'ETINWITHOUTSTEPPINGONTHEBRAKE1.

Insert the ignition key and turn it to the ON position.2.

Now, step on the brake. 3.

The remote control will play the remote start shutdown tone. You have

now taken direct control from the remote start system.

Valet Take-Over

4HE6ALET4AKE/VERFEATUREALLOWSTHEVEHICLETOREMAINRUNNINGAFTER

the key has been removed from the ignition. This feature is useful for

OCCASIONSWHENYOUWISHTOEXITANDLOCKTHEVEHICLEFORSHORTPERIODS

of time, but would like to leave the motor running and the climate

controls on.

4OENABLE6ALETTAKEOVERWHILETHEVEHICLEISRUNNINGPRESS 1 time

and the parking lights will ﬂash after a couple of seconds turn off the

IGNITIONANDTHECARSHOULDSTAYRUNNING/NCEYOUEXITTHEVEHICLEYOU

can lock the system and the car will remain running. If the vehicle shuts

down, then the unit did not enter valet take-over mode.

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 59 60

Pas de commentaire

Viper 5901 Manuel d'instructions Page 19