Viper Fang 28T Spécifications télécharger pdf (Page 8)

to overflow during charging due to expansion.

Replace the caps prior to charging.

5. Plug approved charger into grounded wall

outlet before plugging the charger into the

machine.

6. Plug charger into red charger receptacle

located in the front left of the battery

7. compartment.

8. Flip up the recovery tank “kick stand” and

gently lay the recovery tank down until it rests

on the stand.

9. The charger will automatically begin to

charger the batteries, and it will automatically

shut down once the batteries are fully charged.

10. Upon completion of charging, first unplug the

charger from the wall outlet, and then

disconnect the charger from the machine.

11. Check the battery level after charging is

complete. If fluid level is low, add distilled

water to bring the fluid level up to the bottom

of the sight tubes. Replace the caps and wipe

the batteries down with a towel.

PREVENTATIVE MAINTENANCE

: Before performing any maintenance on

the machine, be sure that the power is turned off,

or the batteries are disconnected!

: Repairs are to be completed by

Authorized Service Centers only. Any repairs

completed by unauthorized persons will void the

warranty.

DAILY MAINTENANCE

1. Remove pad driver / brush and clean with

approved cleaner.

2. Drain recovery and solution tanks completely

and rinse out with clean water. Visually check

the recovery tank for debris and clean out as

necessary.

3. Raise squeegee assembly off floor and wipe it

down with a damp towel. Be sure to store the

squeegee in the up position.

4. Remove the float shut-off assembly and rinse

it out with clean water.

5. Clean machine with an approved cleaner and a

damp towel.

6. Recharge batteries.

WEEKLY MAINTENANCE

1. Check fluid level in batteries.

2. Check batteries for loose or corroded cables.

3. Keep battery tops clean from corrosion.

MONTHLY MAINTENANCE

1. Check machine for leaks and loose fasteners.

2. Lubricate all grease points and pivot points

with silicon spray and approved grease.

3. Place machine over a floor drain. Flush

solution system by pouring 3 gallons of hot

water and approved alkaline detergent into the

solution tank and running machine (with

solution control on) for 45 seconds. Turn

machine off and let it sit overnight. Then next

day, drain the remaining solution and rinse the

solution tank out with clean water.

VACUUM MOTOR MAINTENANCE

8

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 27 28

Commentaires sur ces manuels

Pas de commentaire