Viper 5706V Manuel d'instructions télécharger pdf (Page 45)

Out of Range

Each time a command is performed the remote will expect a com-

mand conﬁrmation from the system. If a command conﬁrmation is not

received the out-of-range icon (

)

and a fault tone will play as an

alert.

No Remote Output

Occasionally when a command is performed the remote may not

generate a command conﬁrmation output or Out of Range output.

This indicates that the system received the command but it was an

incomplete command (e.g. Aux button pressed too short to activate

the trunk release) or it was an illegal message (e.g. the command

was corrupted due to local RF interference). These are temporary nor-

mal functions of the system and remote, perform the command again

within 10 seconds to return to normal operation.

Feature not Available

The

NOT AVAILABLE

message is a generic one which varies in cause

and solution depending upon the command used:

Command Cause Reason/Solution

Runtime Reset Remote Start is Off Only available when Remote Start is On

Sensor Bypass System is not armed Only available when system is armed

Defroster Remote Start is Off.

Not configured for

this.

Only available when Remote Start is On.

Only available when configured for

Defroster control.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 62 63

Pas de commentaire

Viper 5706V Manuel d'instructions Page 45