14 FANG 24TU / FANG 26T / FANG 28T 81086E (1) – 2012-04-10
ENGLISH USER MANUAL
NOTE
If you are filling the solution tank with a bucket, make sure the bucket is clean. This will prevent debris from clogging
the lines or solenoid.
WARNING!
Do not put any ammable materials into solution tank. This can cause an explosion or a fire. Only use reco- mmended
cleaning chemicals. Contact your janitorial supply distributor for recommendations on proper ch- emicals.
MACHINE START AND STOP
WARNING!
Do not operate machine unless you have read and understand this manual.
Set control housing to a comfortable operating height by squeezing together the two thumb levers directly underneath the housing
(see machine components, item #16).
Lower squeegee assembly to the oor by releasing the lift lever from its locked position (see machine components, item #19).
Lower the brush head assembly to the oor by pushing on the brush lift button on the control console (see machine components,
item #7).
Turn main power to “on” position. (see machine components, item #1)
Turn vacuum motor switch to “on” position (see machine components, item #2).
Turn the brush motor switch to “on” position (see machine components, item #4).
a. Brushes will not spin until the operating triggers are pulled.
Turn the solution switch to “on” position (see machine components, item #6).
a. Solution will not begin to ow until the operating triggers are pulled.
To begin scrubbing, pull on one or both of the red operating triggers (see machine components, item #21). When these triggers are
pulled, the brush will begin to spin, the solution will begin to ow, and the machine will propel itself.
This machine is self-propelled. The speed can be controlled by a dial located on the right side of the control housing (see mac-
hine components, item #9).
This machine has reverse. In order to activate reverse, there is a toggle switch located on the left side of the control housing (see
machine components, item #18). The toggle switch must be pulled backwards and the red operating triggers must be pressed to
activate reverse motion.
Adjust amount of solution ow by turning the solution control knob. Turn to the right for more solution, or turn left for less solution
(see machine components, item #8).
WARNING!
Do not keep the machine in the same position with the pad / brush spinning, or you could cause damage to the oor.
NOTE
For correct scrubbing/drying of oors at the sides of the walls, Viper suggests to go near the walls with the right side of
the machine as shown.
CAUTION!
To avoid any damage to the oor surface, turn off the brush/pad-holder when the machine stops in one place, especially
when the extra pressure function is on.
SOLUTION FLOW ADJUSTMENT
Turn the solution switch (A) to “ON” position.
Adjust amount of solution ow by turning the solution control knob (B), turn left (counter-clockwise) for more solution, or Turn right
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels