Viper Fang 28T Manuel d'utilisateur télécharger pdf (Page 15)

81086E (1) – 2012-04-10 FANG 24TU / FANG 26T / FANG 28T 15

USER MANUAL

ENGLISH

(clockwise) for less solution.The pin (C) is limit position of the solution control knob (B).

NOTE

Even if turn on the solution switch (A) ,the solution will not begin to ow until the operating triggers (D) are pulled.

BATTERY DISCHARGE DURING OPERATION

Until the green warning light (3) stays on, the batteries allow the machine to work normally.

When the green warning light (3) turns off, and the yellow warning light (3) turns on, it is advisable to charge the batteries, because

the residual autonomy will last for a few minutes (depending on battery characteristics and work to be performed).

When the red warning light (3) turns on, the autonomy is over. After a few seconds, the brush/pad-holder is automatically tuned off,

while the vacuum system and the drive system stay on, to ﬁnish drying the oor and drive the machine to the appointed recharging

area.

CAUTION!

Do not use the machine with discharged batteries, to avoid damaging the batteries and reducing the battery life.

WHILE OPERATING MACHINE

 Occasionally look through the clear recovery tank lid to see if there is any foam build-up. If excessive foam is found, add defoamer

to the recovery tank.

WARNING!

Foam must not enter the oat shut-off screen, or damage can occur to the vacuum motor. Foam will not activate the

machines oat shut-off device.

 Occasionally view the clear tube at the back left of the machine to check the amount of cleaning solution that is left in the machine.

 Occasionally check the battery level meter (3). When meter is in the red, recharge the batteries.

WARNING!

When battery meter is in the red, do not continue to operate the machine. Battery damage may result.

 If the squeegee assembly leaves streaks on the oor, raise the squeegee off the oor and wipe the blades down with a damp cloth.

WARNING!

Do not use your ﬁngers to wipe or remove debris from the blades, as injury may occur.

 When the solution tank runs empty, turn off the brush switch, solution switch and raise the brush head. Keep the squeegee down

and continue to vacuum until all the dirty water is picked up. (see TANK DRAINING section to learn how to drain recovery and

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 23 24

Pas de commentaire

Viper Fang 28T Manuel d'utilisateur Page 15